RE: 4224-101 Config.

["Andy Nolen-Parkhouse" <aparkhouse@xxxxxxxxx>]

Ken,

Sounds good, although no IPL should be necessary.  If you want a
particular name for the device after it autoconfigures, you can either
use the RNMOBJ command for the DEVD and OUTQ, or just key in new stuff
from the automatically generated descriptions.

Remember to set your address correctly on the 4224, then attach it, then
power it up.  I seem to recall a very recent thread on setting addresses
for a 4224.

Regards,
Andy Nolen-Parkhouse

> admin@midrange.com] On Behalf Of Shields, Ken
> Subject: RE: 4224-101 Config.
>
>       I replaced the 5224 , with a 4224 printer (IBM)
>       Providing the system is set to auto-config, is it ok to delete
> the device description of the 5224, and power on and connect
>       the 4224, and IPL?
>       Auto config should pick up this new device.
>       Haven't had to do this in quite awhile.
> Thanks
>
> Ken Shields