|
Newbie questions are welcome. Here's a chance to check the manual - that's what I had to do - I use these so seldom, I forget. Anyway, the book is at <http://publib.boulder.ibm.com/iseries/v5r1/ic2924/books/c0926050.pdf>, around page 48. Anyway, you put TABS in the sequence number field, then put any character where you want the tabs. Press ENTER. Then ENTER moves from one tab to the next. There's a sessions setting (F13) that will cause tabs to be honored all the time, or type SET TABS ON|OFF in the command line. Regards Vern At 01:43 PM 10/9/02 -0500, you wrote:
Hi all, forgive me the newbie question (I'll have many), but I can't see how to set the TABS in the SEU editor. I checked the archives, but didn't see anything there either. All help is greatly appreciated... 8-) Ray Shahan
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
