Re: Twinax

on the as/400 models where the twinax port was directly
on the back of the machine - yes.
if the as/400 twinax controller has a db25 pin connection, there is
a heavy cable with a block of twinax ports (which I assume
is what you call a twinax hub?) at the other end of the
cable. You cannot bypass that cable/hub.
hth
jim

----- Original Message -----
From: "Matthias Oertli" <matthias.oertli@mdi.com.au>
To: <midrange-l@midrange.com>
Sent: Monday, July 01, 2002 10:43 PM
Subject: Twinax


> Hi all,
>
> Is it possible to connect a single twinax terminal directly to a port on
> a twinax controller using Cat 5 cable and a balun at each end WITHOUT a
> twinax hub? Would this work?
>
> e.g: Twinax Controller - balun ---- cat 5 ---- balun - Twinax Terminal
>
> Thanks for your help.
> Best regards,
> Matthias
>
> --
> --------------------------------------------------
> Matthias Oertli   matthias.oertli@mdi.com.au
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
> To post a message email: MIDRANGE-L@midrange.com
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
> or email: MIDRANGE-L-request@midrange.com
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>
>