|
Cannot see any reason why it would not work. I run the following config with no problems: Twinax ctl - twinax - 5250 display - twinax - balun - cat 5 - balun - twinax - 4028 printer ----- Original Message ----- From: "Matthias Oertli" <matthias.oertli@mdi.com.au> To: <midrange-l@midrange.com> Sent: Monday, July 01, 2002 10:43 PM Subject: Twinax > Hi all, > > Is it possible to connect a single twinax terminal directly to a port on > a twinax controller using Cat 5 cable and a balun at each end WITHOUT a > twinax hub? Would this work? > > e.g: Twinax Controller - balun ---- cat 5 ---- balun - Twinax Terminal > > Thanks for your help. > Best regards, > Matthias > > -- > -------------------------------------------------- > Matthias Oertli matthias.oertli@mdi.com.au > _______________________________________________ > This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list > To post a message email: MIDRANGE-L@midrange.com > To subscribe, unsubscribe, or change list options, > visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l > or email: MIDRANGE-L-request@midrange.com > Before posting, please take a moment to review the archives > at http://archive.midrange.com/midrange-l. >
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
