RE: How do to unattended IPL from control panel in V5R1M0?

I remember using this to power down, but never to power up.

Rob Berendt
--
"They that can give up essential liberty to obtain a little temporary
safety deserve neither liberty nor safety."
Benjamin Franklin



                    Jim Langston
                    <jlangston@celsinc.       To:     
"'midrange-l@midrange.com'" <midrange-l@midrange.com>
                    com>                      cc:
                    Sent by:                  Fax to:
                    midrange-l-admin@mi       Subject:     RE: How do to 
unattended IPL from control panel in V5R1M0?
                    drange.com


                    03/21/2002 04:46 PM
                    Please respond to
                    midrange-l






Ugh.  I can image trying to explain this to someone over the phone when I'm
not in.

Thanks.

I think IBM should rethink this.

Regards,

Jim Langston

From: "Urbanek, Marty" <Marty_Urbanek@stercomm.com>

Jim,

I think you have to do a control panel func 3 to start the IPL. The catch
is, you have to be in manual mode to do the func 3. So you set it for B M
and then do the func 3, and then (while it begins its IPL process) you use
the control panel to change it back to B N. That is what you used to do
when
it was a mechanical key switch and I think that still applies to the new
control panels.

-Marty
_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
or email: MIDRANGE-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.