RE: QESLINE problem on 270

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

RSTCFG OBJ(QESLINE)  
       DEV(TAP01)    

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

-----Original Message-----
From: Art Tostaine, Jr. [mailto:art@link400.com]
Sent: Tuesday, September 19, 2000 11:43 AM
To: midrange-l@midrange.com
Subject: QESLINE problem on 270


I deleted QESLINE and recreated it so that I could change it to use my 270's
internal modem.  Now when I SNDPTFORD, I get a message Line  description not
found.

The SNDPTFORD is getting it's line description from somewhere, and it won't
use my new QESLINE.

I deleted what I did and then called QTIINSTL, but same problem.

How can I get it to use my new QESLINE?  I couldn't change the QESLINE that
was there because I needed to change the interface, and that's only valid on
CRTLINSDLC, not CHGLINSDLC

Thanks.

Art Tostaine, Jr.
CCA, Inc.
Jackson, NJ 08527

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---