Re: 4224 attached to 5294

[Pat Barber <MBOCEANSIDE@xxxxxxxxxxxxxxxxxxxxxxxxxxx>]

bstedman@cis-corp.com wrote:
> 
> The 4224 was configured as a P rinter on the 5294.

Here it is right from the Sales Manual:

5294 Remote Control Unit: 


     An available workstation port and Extended Function A (#3601).
(Remote attachment to System/36
     with SSP at Release 5.1, System/38 with CPF Release 8.0, or AS/400
with OS/400 at Release 1.0
     or higher.) 

5394 Remote Control Unit: 


     An available workstation port. (Remote attachment to System/36 with
SSP at Release 5.1,
     System/38 with CPF at Release 8.0, or AS/400 with OS/400 at Release
1.0 or higher.) 

System Attachment: 

An interface card and twinaxial connector are included with the 4224 for
direct attachment to a System/36
(5360, 5362, 5363, and 5364) Workstation Controller, a System/38
Workstation Controller-Extended, an
AS/400 System Twinaxial Workstation Controller, a 5294 Remote Control
Unit with an available
workstation port and Extended Function A (#3601), or a 5394 Remote
Control Unit with an available
workstation port. Cable-thru and termination are standard through the
use of a U-connector included with
the 4224. System/36 SSP must be at Release 5.1, System/38 CPF must be at
Release 8.0, and AS/400
OS/400 must be at Release 1.0 or higher.
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---