Missing Load Source

["T. Jessica Miller" <tealem@xxxxxxx>]

Hi Everyone,

I need some suggestions on a problem I am having. I have an old 40S that I am
reinstalling (DM IPL then 2 to reinstall and initialize from V3R7 CD's) and am
not able to get it going.  After selecting option 2, it goes for about a minute
(the percentage done stays at 0%) and then gives me a SRCB6005120.  I am able to
boot to DST and selected to Analyze the disk units and got a warning that the
Load Source Disk Unit could not be found.  Plus all my drives read as
non-configured here which seems bad.

If I try to do a BM IPL I can't get to DST and get a SRCB1014505.  This happens
on any other IPL than a DM (off tape or CD).  I even tried one of my savstg
tapes.

This system was up and running about a week ago...until I IPL'd.

Any ideas?

Thanks so much,

Jessica

--
T. Jessica Miller
WRQ Technical Engineer
WRQ Inc, Makers of Reflection and Express Software


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---