Re: Auto dial modem

[pytel@xxxxxxxxxx]

Look at DIALINIT  parameter of controller decription.
It defaults to *LINKTYPE, which is normally same as *DELAY. It means system will
dial out only when session is requested (as in STRPASTHR). If you change it to
*IMMED, system will dial out as soon as you vary on controller description.

Best regards
    Alexey Pytel



Chris.Chambers@v2music.com on 05/05/99 08:03:26 AM

Please respond to MIDRANGE-L@midrange.com

To:   midrange-l@midrange.com
cc:    (bcc: Alexei Pytel/Rochester/IBM)
Subject:  Auto dial modem





I have set up Line, Ctl and dev and vary on Line and Ctl.

I was hoping that the line would go active but this only happens when I attempt
STRPASTHR.

The AUTOCALL and AUTODIAL parameters of the LIND are set to *YES -

how can I invoke an auto dial?

Any ideas


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---