Re: SNDPGMMSG..Call Stack level entry value

[Adhip C Lahiri <Adhip.C.Lahiri@xxxxxxxx>]

Take a look at your call stack..and you will observe that 
*PRV i.e. the entry will be the command processor QCMD where 
it gets displayed....


From:   vtaskar%wipsys.ge.com@Internet on 03/18/99 04:02 AM MST
To:     MIDRANGE-L%midrange.com@Internet
cc:      (bcc: Adhip C Lahiri)
Subject:        SNDPGMMSG..Call Stack level entry value


Hi,

I have a rather elementary doubt..

When a message is to be displayed using the SNDPGMMSG command in a CL
program, the "Call Stack level Entry" can be either *PRV or *SAME...by 
default, it is *PRV.But if we specify the option as *SAME, the message
does not get displayed on the screen, when we run the program...Why?
(If *PRV is given, message is displayed)

Thanks in Advance,

tats!

    ---- Vikas
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---