Re: Operations console on new 170s (V4R3)

[Larry Bolhuis <lbolhui@xxxxxxx>]

One thing to try (it worked for us and the CE was the one who suggested it) is
to remove the cable for the ECS modem from the system (Remove the AS/400 end) 
This seemed to be needed only for the initial contact. After that having the
modem connected did not seem to matter.

HTH - Larry  

Mordechai Gluck wrote:
> 
> Hi all,
> 
> I am having a problem getting Operations Console on new 170s (V4R3) to work.
> 
> Followed all directions and tips I could find, read and checked everything,
> and still no go.
> 
> I am using NT on a PentiumII Compaq DeskPro with 64 meg RAM.
> Installed Client Access and latest service pack.
> RAS installed, then Service Pack 3.
> Both Connection and com port set to 115200bps.
> PC com port loopback tested and working correctly.
> Console cable (44H7504) attached to correct PC com port and AS400 card.
> 
> I keep getting the message saying console communication port could not be
> found.
> 
> Any ideas?
> 
> Thanks
> Tom Czirok
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---

-- 
Larry Bolhuis         |
Arbor Solutions, Inc  | Two rules to success in life:
(616) 451-2500        | 1. Never tell people everything you know.
lbolhui@ibm.net       |
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---