RE: TCP/IP printing problem

[Omprakash Maniyar <OManiyar@xxxxxxxxxxxxx>]

we in addition specify AUTOSTRWTR(1)  SEPPAGE(*NO).. If you don't
specify the AUTOSTRWTR then you have to do STRRMTWTR to actually start
it..

Om @Ext 4774

> -----Original Message-----
> From: Marc Zylka [SMTP:mzylka@netpath.net]
> Sent: Saturday, April 25, 1998 5:33 PM
> To:   MIDRANGE-L@midrange.com
> Subject:      Re: TCP/IP printing problem
> 
> Eric,
> 
> >I am attempting to connect an Epson DXF5000 printer via a HP Jet
> Direct EX
> >card to the AS/400 version 4.1 - 620 e-series.  I have created the
> >following outq description:
> 
>   We're running on a 620 at V4R1 and I've set up printing to a Jet
> Direct card using the following parameters in the output queue
> definition:
> 
>     Remote system: *INTNETADR
>     Remote printer queue: *NONE
>     Connection type: *IP
>     Internet address: xxx.xxx.xxx.xxx
>     Destination type: *OTHER
>     Host print transform: *YES
>     Manufacturer type and model: should be fine as you have it
> 
>   I did not set up the IP address in the Host Table Entry and it works
> fine as defined above.
> 
> 
> >Also, we have found that we can not connect to our RISC system using
> >NSRouter.  We can connect via TCP/IP.
> 
> 
> Don't know about this one.  Ours works fine with NS/Router, we use
> NetSoft Elite using Direct TCP/IP or Anynet.
> 
> Marc ( mzylka@netpath.net )
> 
> 
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To unsubscribe from this list send email to
> MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
> david@midrange.com
> +---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---