RE: "Naming" a PC5250 Device (session) in CA NT... -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


> Hello Folks,
> 
> I apologize if this has ALREADY been discussed (and I have a WAY to
> vague recollection that it has...) but is there ANY WAY to NAME the
> PC5250 Display Session when running CA for NT ?  The Configure PC5250
> screen has the Workstation ID section "greyed out"...
> 
> We are connecting to the AS/400 via TCP/IP also...
> 
Chuck,  
        To assign a device name, you need APPC. You can connect via TCP/IP, but
using APPC over TCP/IP (Anynet). You need to use the NS/Router with any of
the communication stacks supported, either 802.2, Twinax or TCP/IP.

Hope this helps.


Hector E. Estigarribia
estigarribia@usa.net

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.