Re: MI program unable to locate job - need assistance

On 16/05/2008, at 9:04 AM, Paul Jackson wrote:

Sorry, I was a bit premature with that statement. The pointers are at
the normal position but for some reason it seems as if the SETSPPFP
.WCBSPC, .WCB-TABLES(THE-TABLE); statement is not setting .WCBSPC
properly as the based on structure is all hex zeros.

That's very odd. Can you recompile it with debuggable identifiers and
determine what .WCBSPC is set to before and after the SETSPPFP
operation?

You said you were running this on VRM540, QSECURITY=40, and program
set to system-state. I compiled on 510, set system state (including
proper checksums) and tried it and it worked. I then saved the
program and test program, restored on VRM540, and tried it, and it
worked,

So the code seems fine--although it's not the most efficient way of
locating a given job.

I wonder what else is different on the failing system? Same level of
LIC? Same Cume level?

Regards,
Simon Coulter.
--------------------------------------------------------------------
FlyByNight Software OS/400, i5/OS Technical Specialists

http://www.flybynight.com.au/
Phone: +61 2 6657 8251 Mobile: +61 0411 091 400 /"\
Fax: +61 2 6657 8251 \ /
X
ASCII Ribbon campaign against HTML E-Mail / \
--------------------------------------------------------------------



_______________________________________________
This is the MI Programming on the AS400 / iSeries (MI400) mailing list
To post a message email: MI400@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mi400
or email: MI400-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mi400.