Re: [MI400] Inactive time for jobs in DSPW condition

["Simon Coulter" <shc@xxxxxxxxxxxxxxxxx>]

Hello Doug,

You wrote:
>I don't know if the system task disptacher checks idle time vs QINACTITV,
>or if when QINACTITV is given, a timer is started after each I/O.  If
>there is a timer, then it is conceivable the information is not readily
>available.

I don't know which part of the system tracks the inactive time interval (I
suspect it would be the subsystem monitor) but I know there is a bit in
the Work Control Block for a job that, if set, indicates the job has
exceeded the QINACTITV time.  Would that help?

Regards,
Simon Coulter.
--------------------------------------------------------------------
   FlyByNight Software         AS/400 Technical Specialists
   http://www.flybynight.com.au/

   Phone: +61 3 9419 0175   Mobile: +61 0411 091 400        /"\
   Fax:   +61 3 9419 0175   mailto: shc@flybynight.com.au   \ /
                                                             X
                 ASCII Ribbon campaign against HTML E-Mail  / \
--------------------------------------------------------------------