Re: Retrieving data from a Data Queue -- MI400

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

I last did this more than ten years ago, I seem to remember the MI command 
was MATQMSG.

Regards,
Rich

At 07:02 PM 5/22/05 +0000, you wrote:
>How can I retireve the data from a data queue without removing the
>data.  Using the QRCVDTAQ program removes the data from the queue, can I
>read a data queue with an MI program and not remove the data.
>
>Thanks,
>
>Allen Hartley
>
>+---
>| This is the MI Programmers Mailing List!
>| To submit a new message, send your mail to MI400@midrange.com.
>| To subscribe to this list send email to MI400-SUB@midrange.com.
>| To unsubscribe from this list send email to MI400-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator: dr2@cssas400.com
>+---

Regards,
Rich

+---
| This is the MI Programmers Mailing List!
| To submit a new message, send your mail to MI400@midrange.com.
| To subscribe to this list send email to MI400-SUB@midrange.com.
| To unsubscribe from this list send email to MI400-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: dr2@cssas400.com
+---

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.