Re: Problem with TN5250

["John Aldrich" <jaldrich@xxxxxxxxxxxxxxxxxxx>]

Using straight TN5250 in a terminal window. Xt5250 can be used, but I need
to tweak it as the default font settings are incredibly small!

As I said in my original email the "error reset" key is normally "control"
but it's not working on this basic tn5250 session.




-----Original Message-----
From: linux5250-bounces@xxxxxxxxxxxx [mailto:linux5250-bounces@xxxxxxxxxxxx]
On Behalf Of Scott Klement
Sent: Friday, June 10, 2011 1:00 PM
To: Linux 5250 Development Project
Subject: Re: [LINUX5250] Problem with TN5250

Which front-end to TN5250 are you using?  Curses? Slang? xt5250? x5250? 
gtk-5250?

This "error" is obviously an issue that you don't know where the "error 
reset" key is on your keyboard, but I can't assist unless I understand 
your environment.


On 6/10/2011 11:01 AM, John Aldrich wrote:
> Trying to use TN5250 here on a Debian box. It works fine until we get an
> error message and then it locks up the whole session and we have to close
> the window and restart it. Unfortunately that is a non-starter.
>
> This is not a "critical" error... just a warning, in this case, it's
telling
> us that we haven't entered any roll numbers for the carpet and we should
> enter some roll numbers... but we can't get that far because it's blocking
> us. On the official Windows 5250 client, we just hit "ctl" and it goes
away
> and we can proceed. However, that doesn't work for us with TN5250.