RE: Lost ability to verify

["Westdorp, Tom" <Tom.Westdorp@xxxxxxxxxxxxxxxxxx>]

John,

Interesting thought, thanks, but no nested /copies.  Along those lines
though one of the changes I made was to use conditional compile statements
in the main code for the defined release, I wonder if that could be
confusing the verifier?  I'll cobble something together in the morning and
check that out.

Tom

-----Original Message-----
From: John Taylor [mailto:lists@xxxxxxxxxxxxxxxxxxxx]
Sent: Tuesday, February 25, 2003 2:36 PM
To: CODE/400 Discussion & Support
Subject: Re: Lost ability to verify


Tom,

I had a similar problem which had me pulling my hair out for a couple of
hours before I finally figured it out. Check all of the /copy members in
your source file to see if they contain nested /copy statements. If so, it's
likely that one of the nested source members does not exist in the file
where the verifier is expecting to find it.

Regards,

John Taylor


----- Original Message -----
From: "Westdorp, Tom" <Tom.Westdorp@xxxxxxxxxxxxxxxxxx>
To: <code400-l@xxxxxxxxxxxx>
Sent: Tuesday, February 25, 2003 3:08 PM
Subject: Lost ability to verify


> Trying to verify, with prompt and a cache refresh, a service program and
it
> bombs with (I think):
>
> CODE.LOG:
> General Protection Fault exception occurred at EIP = 035BA04A on thread
> 04FC.
> Register Dump at point of exception:
> EAX = 0012DC14    EBX = 03747E58  ECX = 00000006    EDX = 00000030
> EBP = 0012DC48    EDI = 00000004  ESI = 03747E59    ESP = 0012DBE4
> ÿCS =     001B  CSLIM = FFFFFFFF   DS =     0023  DSLIM = FFFFFFFF
> ÿES =     0023  ESLIM = FFFFFFFF   FS =     003B  FSLIM = 00000FFF
> ÿGS =     0000  GSLIM = 00000000   SS =     0023  SSLIM = FFFFFFFF
> NPX Environment:
> CW = 0262      TW = FFFF  IP = 3605:077D001B
> SW = 0100  OPCODE = 077D  OP = D3AC:FFFF0023
> NPX Stack:
> No valid stack entries.
> Process terminating.

_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/code400-l
or email: CODE400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.

NOTE: WDSc for iSeries disucssion has it's own mailing list.
Information can be found at
http://lists.midrange.com/cgi-bin/listinfo/wdsc-l