RE: Changes lost after receiving "Member locked" message

["Reeve Fritchman" <reeve@xxxxxxxxxx>]

A clarification: when I'm in the office, I'm using a Netgear RT-314
connection sharing device (it provides NAT service) to connect three PC's to
my cable modem.  I can't figure out how to get the iSeries STRCODE command
to work in this environment (I think the NAT is screwing things up) so I
rely on the PC-based communications daemon.  This was the environment  where
the "Member locked" problem occurred.

When I'm away from the office and dialed in, STRCODE works fine and I can
use PDM to initiate CODE/400 functions.  Usually right-clicking on the
communications daemon terminates the STRCODE function normally.

-rf

-----Original Message-----
From: code400-l-admin@midrange.com [mailto:code400-l-admin@midrange.com]On
Behalf Of Phil Groschwitz
Sent: Thursday, February 28, 2002 8:48 AM
To: code400-l@midrange.com
Subject: RE: Changes lost after receiving "Member locked" message

>
> Reeve: was that you cannot kill the daemon when it
> was locked?
> I agree. There are still more work for me on this
> data lost problem. I
> appreciate your feedback.
>
Here's some feedback:

Sometimes when editing a source file on the host with
CODE, after closing the editor the STRCODE job still
has a lock on the member.  I can reopen it in CODE but
not in SEU.  The only way I've found to get rid of the
lock is to end the STRCODE server and signoff.

Phil

__________________________________________________
Do You Yahoo!?
Yahoo! Greetings - Send FREE e-cards for every occasion!
http://greetings.yahoo.com
_______________________________________________
This is the CODE/400 Discussion & Support (CODE400-L) mailing list
To post a message email: CODE400-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/code400-l
or email: CODE400-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/code400-l.