Re: New Version Help !

[batthish@xxxxxxxxxx]

Hi Cindi,

Basically you are receiving this message because CODE/400 already thinks
that there is a server running with that name.

There are a couple of things you can do:
1) When you issue the STRCODE command, specify a different name on the
SERVER parameter.  This would be the simplest way.
2) Ensure that the server is no longer running in CODE tools.
   To do this:
   Go to the properties dialog as you had before.  If there is a server
   listed with that name, select it.  If the shutdown button is not greyed
   out, it is because it is a STRCODE server, and you can press the
   Shutdown button to shutdown the server.  (auto-connect servers cannot be
   shutdown)
   If the server is auto-connect then after selecting the server node, you
   can simply change the CODE/400 server name and press the Change button
   to register this to CODE/400.
   If no server with the same name is listed, check that the auto-connect
   servers do not have the name you want to use.  Rectify the situation the
   same way descibed in the previous item.


The reason this may seem to have appeared is probably because you used the
Host Configuration Wizard (new in V4R5M1) to define a new server which has
the same name as the one you normally use in the STRCODE command.

Hope this helps!

Violaine Batthish
CODE/400 Project Lead
batthish@ca.ibm.com          IBMCA(BATTHISH)

CODE/400 page:  http://www.ibm.com/software/ad/varpg
CODE/400 Support : http://www.ibm.com/software/ad/varpg/support


+---
| This is the CODE/400 Mailing List!
| To submit a new message, send your mail to CODE400-L@midrange.com.
| To subscribe to this list send email to CODE400-L-SUB@midrange.com.
| To unsubscribe from this list send email to CODE400-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: larry@paque.net
+---