James
I am not an RPG programmer so I am stepping out on a limb. But I seem to
remember from previous discussions that RPG does not have to be set to use
Teraspace, it always does. C on the other hand does not, it has to be told
that you want to use teraspace specifically, turning it on in the MODULE
requires the compile to be carried out with the support, the program can be
compiled without TS support even if the module has it. So you may have a
module that is capable of addressing TS but the program does not. Not sure
why one specific install would have the issue? But then IBM does not say
when it will load the data into TS, it just does it when it determines it is
the right place to do it.
I have seen similar results when I was addressing journal ESD data,
sometimes it would be OK other times it was not when TS was not turned on in
the program and the module..
Chris...
______________________________________________________
Please consider the environment before printing this email.
This message, including any attached documents, is intended for the
addressees only. It may contain information that is confidential, privileged
and/or exempt from disclosure. No rights to privilege or confidentiality
have been waived. Any unauthorized use or disclosure is prohibited. If you
have received this message in error, please reply to the sender by e-mail
and delete or destroy all copies of this message.
______________________________________________________
Avant d'imprimer ce courriel, pensez à l'environnement.
Ce message, incluant tous les documents joints, est à l'intention des
destinataires visés seulement. Il peut contenir des renseignements
confidentiels, protégés et/ou ne pouvant pas être divulgués. Aucune
renonciation n'est faite quant à sa nature confidentielle et privilégiée.
Par conséquent, toute diffusion ou utilisation non autorisée est strictement
interdite. Si vous avez reçu ce message par erreur, veuillez en aviser
immédiatement l'expéditeur par retour de courriel et en détruire toutes les
copies existantes.
-----Original Message-----
From: c400-l-bounces+chrish=shieldadvanced.ca@xxxxxxxxxxxx
[mailto:c400-l-bounces+chrish=shieldadvanced.ca@xxxxxxxxxxxx] On Behalf Of
James Lampert
Sent: September-26-11 2:40 PM
To: C programming iSeries / AS400
Subject: Re: [C400-L] Weird error on a memcpy() that's been working,
unaltered, for years
Chris Hird wrote:
Make sure the C module/program is complied with TERASPACE support, RPG
is done automatically so it may be writing the data to a teraspace
location?
This is weird: if I look at the modules with a DSPMOD, teraspace support is
turned off, across the board, both C and RPG.
But if I look at them in the program, from the *MODULE page of DSPPGM, they
all show teraspace support turned on, across the board, both C and RPG.
This doesn't add up. But a teraspace conflict doesn't explain why it would
suddenly stop working at one (and only one) installation, over a weekend,
with no changes to any of our stuff.
--
JHHL
--
This is the C programming iSeries / AS400 (C400-L) mailing list To post a
message email: C400-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list
options,
visit:
http://lists.midrange.com/mailman/listinfo/c400-l
or email: C400-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/c400-l.
midrange.com
