Do you use BPCS EAM (Plant Maintenance)? If you do, then I believe the interface program, AMI is also intalled. If this is the case, then most of the setups are done in EAM. Check the address master EADDRS in MMS610F or MMS810F (v6 or v8). It should either start with or without a 'V'.

Regards,

Isaac

-----Original Message-----
From: "Kobie Jooste" <kobie.jooste@xxxxxxxxxxxx>
To: "bpcs-l@xxxxxxxxxxxx" <bpcs-l@xxxxxxxxxxxx>
Sent: 15/09/08 11:43
Subject: [BPCS-L] Vendor Creation: "Vendor Cannot be added - already existsin MMS"

We're trying to add a Vendor via ACP100 and when pressing F6=Accept, this
error appears - "Vendor Cannot be added - already exists in MMS"

Any Idea?

Kobie Jooste - Manager: ERP Systems
kobie.jooste@xxxxxxxxxxxx
Tel: +2711 758 5387 | Mobile: +2779 884 0161 | Fax: +2711 388 5927

This email and all contents are subject to the following disclaimer:
http://disclaimer.clover.co.za

This email and all contents are subject to the following disclaimer: http://disclaimer.clover.co.za

As an Amazon Associate we earn from qualifying purchases.

This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2022 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.