Does any one know if it is possible, when you declare production and
backflush components on the BOM, to add back into stock on the same

Eg.  During production, excess plastic is trimmed which can then be
reground and reused, is it possible to add the regrind back into stock at
the same time as declaring production of the parent item and backflusing
the component parts.... ?  Have tried a negative quantity on the BOM


This e-mail contains information that may be confidential or privileged. If you 
are not the intended recipient please note that any copying, use, distribution 
or taking any action in reliance on the contents of this e-mail is prohibited 
and unlawful. If you have received this e-mail in error, please notify the 
sender by telephone or e-mail immediately. Any opinions expressed are those of 
the author and do not necessarily represent the views of Syan Ltd. This e-mail 
does not constitute either offer or acceptance of any contractually binding 
agreement; such offer or acceptance can only be communicated in writing.

Syan reserves the right to monitor and intercept e-mails sent and received on 
our network.

In accordance with good computing practice the recipient is advised to ensure 
that this e-mail is virus free.

This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2020 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].