Re: (no subject)

["Robert M. Gauthier" <rgauthier@xxxxxxxxxxxxxxxx>]

If you are doing Lot Control, you could populate the Country of Origin 
code with the facility code that it was produced in on the Lot Master 
File - ILN.  This will allow you to identify shipments by the lot-# 
shipped and map back from the lot header to get the correct facility to 
get the standards from file - CMF

Deb Newcomb-Burke wrote:

> Ron,
>
> The mfg costs are captured properly.  Our problem is that regardless of
> the components or mfg location, all are using the same F/G item number.
> So, we have xxx product in our finished goods warehouse with multiple
> costs.  Once we generate a customer order, we allocate by lot for FIFO.
> At this point we really don't know how much that particular item costs
> for a true margin picture
>
> Deb Newcomb-Burke
> IT Director - Alba/Tefron-USA
> 828-879-6518
> 336-682-4493 - cell
> 240-306-2681 - efax
> debnewcomb-burke@xxxxxxxxxxxxx
>
> -----Original Message-----
> From: bpcs-l-bounces+debnewcomb-burke=tefronusa.net@xxxxxxxxxxxx
> [mailto:bpcs-l-bounces+debnewcomb-burke=tefronusa.net@xxxxxxxxxxxx] On
> Behalf Of Ronald Smith
> Sent: Tuesday, October 11, 2005 3:35 PM
> To: 'SSA's BPCS ERP System'
> Subject: RE: [BPCS-L] (no subject)
>
> The only way to capture actual costs is from the closed shop orders.
> +With their being at different locations, then the actual costs will
> change with each shop order closed.
>
>
> Ron Smith
> 704/864-2499    (home office)
> 704/674-1121      (mobile)
> 704/864-3431     (fax)
>
>
> -----Original Message-----
> From: bpcs-l-bounces+rsmith17=carolina.rr.com@xxxxxxxxxxxx
> [mailto:bpcs-l-bounces+rsmith17=carolina.rr.com@xxxxxxxxxxxx] On Behalf
> Of Deb Newcomb-Burke
> Sent: Tuesday, October 11, 2005 3:08 PM
> To: bpcs-l@xxxxxxxxxxxx
> Subject: [BPCS-L] (no subject)
>
>
>  
>
> To All,
>
>
>
> We have a situation where a single product can be made at several
> locations around the world.  The manufacturing location has a direct
> bearing on the mfg cost.  Within these locations the product can be made
> of cotton or polyester which also is reflected on the cost.  We are
> manufacturing all of the different scenarios with alternate BOM methods
> and corresponding alternate routing method.  My question is how can we
> capture the actual cost so a true margin can be calculated for customer
> orders?
>
>
>
>
>
> Deb Newcomb-Burke
>
> IT Director - Alba/Tefron-USA
>
> 828-879-6518
>
> 336-682-4493 - cell
>
> 240-306-2681 - efax
>
> debnewcomb-burke@xxxxxxxxxxxxx 
>
>
>
>
>