× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. BPCS-L
  3. July 2002

Re: qty issued to a work order

We close orders daily.  We created a program that reduces the FSO Qty
to make to the actual Qty Made.

Bill

----- Original Message -----
From: "Chick Doe" <Cdoe@barton-instruments.com>
To: <bpcs-l@midrange.com>
Sent: Tuesday, July 09, 2002 12:10 PM
Subject: qty issued to a work order


suppose we cut a work order that requires 14 feet of raw material.
suppose we then go to the stockroom and find a 12 foot bar of raw
material and we issue the 12 feet to the work order. this still leaves
a requirement for 2 feet for that work order. is there any way to tell
bpcs that the 12 feet that was issued is all that is going to be
issued to that work order, ie kill the remaining requirement for the 2
feet? the only way that i know how to do this is to go into the work
order and change the required qty on the work order to a lesser
amount.

As an Amazon Associate we earn from qualifying purchases.

This thread ...
Replies:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.