We usually retrieve the spool file attributes to get the CPI and
perform an OVRPRTF. If the value is 10 CPI we override it to 12,
if 15 CPI or greater we override to 20.


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Donker,
E (Erwin)
Sent: Friday, April 04, 2014 3:21 AM
To: midrange-l@xxxxxxxxxxxx
Subject: Spoolfile gets cut off on PDF using Infoprint Server


My company is using Infoprint Server to convert spoolfiles to
PDF and put
them on the network or send them by email. This works fine,
except for the
spoolfiles that are wider than 138 characters.

For example, we have a spoolfile that is 183 characters wide.
If we sent this
spoolfile to the network as PDF using Infoprint Server, all
characters from
139-183 are cut off and not shown on the PDF.

I tried searching the net for parameters that allow me to
configure the width
of the PDF file, but haven't been able to find any. Could
anyone guide me to
finding a solution for this problem?

Kind regards,

Erwin Donker

Confidentiality Notice:

The preceding e-mail message (including any attachments) contains information that may be confidential, protected by applicable legal privileges, or constitute non-public information. It is intended to be conveyed only to the designated recipient(s). If you are not an intended recipient of this message, please notify the sender by replying to this message and then delete it from your system. Use, dissemination, distribution or reproduction of this message by unintended recipients is
not authorized and may be unlawful.

This thread ...


Return to Archive home page | Return to MIDRANGE.COM home page