at v6r1, if you have QCTL as controlling sbs (see sysval qctlsbsd)
this is the order in the shipped qstrup clp
(after qserver & qusrwrk (and i usually add a delay here..)
QSYS/STRSBS SBSD(QINTER)
QSYS/STRSBS SBSD(QBATCH)
QSYS/STRSBS SBSD(QCMN)
QSYS/STRSBS SBSD(QSPL)
start writers...
Jim Franz
----- Original Message -----
From: "Gary Thompson" <gthompson@xxxxxxxxxxx>
To: "Midrange Systems Technical Discussion" <midrange-l@xxxxxxxxxxxx>
Sent: Friday, September 14, 2012 5:45 PM
Subject: Custom startup program
I was just asked to check our modified startup program (late Friday, is
there no justice?).
So, I'm definitely not the best fit for this, but here is my question:
Is there any recommended order for starting subsystems?
The startup pgm being replaced did the following as it's first four:
QSPL
QINTER
QBATCH
QCMN
Any hints, comments, or pokes welcomed...
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.
