× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. MIDRANGE-L
  3. September 2007

RE: Best Manual for Scratch Install

From: Pete Massiello

Joe,

I would put the Twinax card in position C06, the Communication (2793
or 2791 type of card would have the four lights on it in one corner) card
would go above that in C07, and I would have the Ethernet in C02. That is
how we have all our 270s set. Because any of those 3 cards could be a
console (twinax, Direct Ops Console, and Ethernet Ops Console).

I would also assume that if you have Twinax Console, that its
connected to Port 0 on the Twinax hub, and the Twinax terminal is at
Switch Setting Zero.

Thanks, Pete!

Remember, as of this morning this machine was fully functional as a V5R1
machine, so it clearly CAN talk to the twinax console. I'm going to replace
the V5R1 disks and IPL off of B just to make sure I didn't really hose
something.

Then I'll try to move the cards.

Joe



As an Amazon Associate we earn from qualifying purchases.

This thread ...
Replies:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.