Re: Automatically set screen field values

Set up an iSeries Access PC5250 macro - easy to do, and you can pass it around 
for others to install on their PC. Record the strokes you want and, bad-a-bing, 
you're there.

-------------- Original message -------------- 

> 
> 
> 
> 
> Hi All, 
> have a situation where I would like to run the STRQM command, 
> automatically enter "1" in the selection field on the Menu screen and force 
> an to be performed, to get me to the Work With screen. (Ideally I 
> would like to set fields on the following screen as well, but one thing at 
> a time.) 
> 
> Does anyone know if its possible to do this, is there an API out there 
> waiting to be used? 
> 
> regards 
> 
> 
> James O'Sullivan 
> Senior Technical Consultant 
> email: josulli4@xxxxxxx 
> Office: +44 1252 536681 
> Fax: +44 1252 534022 
> www: www.csc.com 
> Based at: Tower 2, Floor 2, Royal Pavilion, Wellesley Road, Aldershot, 
> Hampshire, GU11 1PZ 
> 
> CSC Corporation Limited: No. 1812179. 
> All registered office addresses: Royal Pavilion, Wellesley Road, Aldershot, 
> Hampshire, GU11 1PZ. Registered in England. 
> 
> -- 
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list 
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx 
> To subscribe, unsubscribe, or change list options, 
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l 
> or email: MIDRANGE-L-request@xxxxxxxxxxxx 
> Before posting, please take a moment to review the archives 
> at http://archive.midrange.com/midrange-l. 
>