|
Tom,
The way I read it, it was more of warning that was worded poorly but I knew what it meant. It takes an IPL to apply no matter how it is done, immediate or delayed. It was worded poorly at best.
Here's a good one for you. I am getting ready to take our Model 270 up to V5R2. I downloaded the PTF's so that I could build an Image Catalog for the install of V5R2. In the cover letter for 5722SS1 SI03120, which gives the instructions for building and using the image catalog at V5R1, has a paragraph that is so circular it is not funny. On page 6, the first paragraph under the -- RESTRICTIONS -- section it says:
"This PTF supports only the preparation and upgrade to V5R2M0 and subsequent supported upgrade paths from V5R1M0. PTF and Licensed Program installation are not supported in V5R1M0. If you have PTF or Licensed Program images you can load these images in the image catalog being used for the upgrade."
So, can I load the PTF CUME as an image in the catalog or not? The above paragraph tells me I can't but yet I can in the same paragraph! That's right up there with "This Page Intentionally Left Blank." :-)
Just for grins, does anyone know if the CUME Package can be loaded and applied from the Image Catalog while still at V5R1 and apply it once V5R2 is installed?
Regards,
Mike Shaw
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.