RE: Automated File Transfer Question

I think it must be the Express version. If I right-click the desktop, select 
New | Data transfer from AS400, I get an icon labeled "New Data Transfer From 
AS400.tto"

-----Original Message-----
From:   owner-midrange-l@midrange.com  On Behalf Of dhandy@isgroup.net
Sent:   Monday, May 24, 1999 12:15 PM
To:     MIDRANGE-L@midrange.com
Subject:        Re: Automated File Transfer Question

David,

>Is this something new in V3R2? We're still using CA V3R1M3; there's no Start  
>Up 
>tab under properties and transfers  can only be saved as *.TTO (to) or *.TFR 
>(from).

Could be -- this is using the Data Transfer of Client Access Express
V4R4M0  (Beta), but I'm still running V3R7 for the OS level.

I was thinking that even the non-Express version of CA used
*.dtt/*.dtf for data transfers, and the *.tto/*.tfr were just for
RFROMPCB/RTOPCB but perhaps I mismember.  

Make sure you run Data Transfer -- e.g. right-click the desktop and
select New, then Data Transfer to (or from) the AS/400.

Doug
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---