Re: STRPASTHR Help Please

["Carl Galgano" <cgalgano@xxxxxxxxxxxxxxxxx>]

On the system you are trying to pass thru to, be sure the value of QAUTOVRT
is set to at least 10.
CJG
Carl Galgano
EDI Consulting Services, Inc.
540 Powder Springs Street
Suite C19
Marietta, GA  30064
770-422-2995
mailto: cgalgano@ediconsulting.com
http://www.ediconsulting.com
EDI, Communications and AS400 Technical Consulting

-----Original Message-----
From: T. Jessica Miller <tealem@wrq.com>
To: MIDRANGE-L@midrange.com <MIDRANGE-L@midrange.com>
Date: Tuesday, May 04, 1999 9:03 PM
Subject: STRPASTHR Help Please


>Hi All,
>
>I need some help (if you get this message twice, my apologies, but I don't
think
>it went out correctly the first time).  For some reason which is failing to
>become obvious to me, I am unable to get passthru working from one of
systems
>(systemA - V3R7) to another system (systemB - V4R3).  However, SystemB can
>passthru to SystemA just fine.  When I run the command STRPASTHR (no
devices,
>controller, etc specified) it gives me the ' Pass-through initialization in
>progress ' and then eventually gives the error:
>
>Message ID . . . :  CPF8921
>Message . . . . :   APPC failure. Failure code is X'0009000000000000'.
>Cause . . . . . :   An APPC failure occurred while pass-through was using
device
>SystemB on system SystemA. The first four digits of the failure code
contain the
>reason code.  The remaining digits contain sense data. Values   for the
first
>four digits of the failure code are:
>
>0009 -- Activate session timed out.
>
>So this is obvious, but why is it timing out?  I have compared APPN and
APPC
>information for both systems and they are, for all intents and purposes,
the
>same.  I have been through IBM's web site with little luck, as well as the
Remote
>Workstation Guide.
>
>Any ideas would be greatly appreciated!
>
>Thank you,
>
>Jessica
>
>
>
>
>+---
>| This is the Midrange System Mailing List!
>| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
>| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
>| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator:
david@midrange.com
>+---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---