Re: XMLSERVICE with .Net

On 2012-08-05, at 1:00 PM, web400-request@xxxxxxxxxxxx wrote:

Eh, I'm confused now. I was following Nathan just fine: if you're
calling a routine directly from a CGI program then why is it any slower
than calling it via the database service program (the QZDASOINIT program
we know and love)?

The (slight) overhead would mostly be in the CGI program reformatting the XML packet to match the requirements of the stored procedure.

You seem to be implying that the CGI program can only access the
underlying XMLSERVICE program through a stored procedure. Nathan seems
to think (and I would agree) that you can skip the stored procedure
entirely and just call the program that the stored procedure calls.

I'm not implying anything. It is my understanding that this is the way it works. That the CGI job invokes the stored procedure. It does not attempt to go direct to the underlying code. I don't disagree that it would seem that you could skip the stored procedure - you'd have to ask Ranger (Tony Cairns) about that.

That said - I have not tested personally the comparative speed of the two approaches but I thought Ranger had and that those tests were the basis for the speed warning on the site. The tests themselves may be on the site - I haven't got time to look right now.

Either way - nobody is critiquing the speed of CGI. The comments relate only to the relative performance of the two ways of using XMLSERVICE - period - end of story.


Jon Paris

www.partner400.com
www.SystemiDeveloper.com