An uninstall and reinstall of the licensed program seemed to do the trick.
I don't know what happened with the original install. I can now see the
admin page on port 89. So far, so good.
Thanks,
Todd
Jon Paris
<Jon.Paris@Partne
r400.com> To
Sent by: web400@xxxxxxxxxxxx
web400-bounces@mi cc
drange.com
Subject
Re: [WEB400] Zend install problem
2009-03-13 13:11
Please respond to
Web Enabling the
AS400 / iSeries
<web400@midrange.
com>
On 13-Mar-09, at 12:40 PM, web400-request@xxxxxxxxxxxx wrote:
I've verified that port 8000 is open. This is looking more like an
install
problem. There are no jobs in the ZEND sbs and no ZENDADMIN user
profile.
Port 800 is used internally so I doubt it needs to be open. I have
never had to do it.
Did you default the install to port 89?
What happens when you use the start up commands in the ZCMENU? Are no
error messages issued?
I did have a similar problem some 18 months ago - and it was because
two the pre-req components were missing and at that time the install
did not check for them - I think it does now but ...
Have you opened a support ticket with Zend?
Jon Paris
www.Partner400.com
www.SystemiDeveloper.com
--
This is the Web Enabling the AS400 / iSeries (WEB400) mailing list
To post a message email: WEB400@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/web400
or email: WEB400-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/web400.
This communication and any transmitted documents are intended to be confidential. If there is a problem with this transmission, please contact the sender. If the reader of this message is not the intended recipient, or the employee or agent responsible to deliver it to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited.
midrange.com
