Hi group,

I created a small command to check out sources on our system (as we don't
have a real source management system).

The command has a CLLE program which performs the actions (copy to backup,
copy to devlib etc) and an RPGLE validator which does some basic checks
(source must exist, devlib must exist etc).

If I run the command in PDM on 5250 the processing stops if the validator
encounters a problem.

However, in RDi no error is displayed in this case, although no action is
taken. This behaviour is the same with or without prompting the user action.

I have to go into the commands log view to find out if anything went wrong
or not.

Is there any way to have the error shown when I click "OK" on the user
action command prompt? I went through the preferences but I can't seem to
find anything related to this.



Peter Colpaert


As an Amazon Associate we earn from qualifying purchases.

This thread ...

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2022 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.