Re: Convert to freeform

Jeff, I feel your pain (and may have been a participant in the thread from awhile back).
I agree that it would be nice if that was a high priority of the RDi Enhancements team.

That said, I have had great success with using the "Right-click in the LPEX editor > New > D-spec method of developing my expertise.
Try it... You'll like it. Until you get good enough to get along without it.

Michael Koester
Programmer/Analyst
~~~~~~~~~~

-----Original Message-----
From: WDSCI-L [mailto:wdsci-l-bounces@xxxxxxxxxxxx] On Behalf Of Jeff
Crosby
Sent: Thursday, February 18, 2016 1:30 PM
To: Rational Developer for IBM i / Websphere Development Studio Client for
System i & iSeries
Subject: [WDSCI-L] Convert to freeform

RDi has long converted C specs to freeform. I highlighted some D specs,
right-clicked, and saw the "Convert selection to Free-Form." Alright! I
thought, just what I want.

However...it doesn't. Found a thread from a couple of years ago where the
only available ones were pay versions from Arcad and Linoma.

That still true? Does either do it within the RDi editor? I'd rather do
'chunks' of H, F, and D specs than an entire member. I'd like to look at
the before and after of my own code to learn it better. The vast majority
of my C specs are already freeform.

I don't write much new code these days, but do a lot of maintenance.

Thanks.

--


Jeff Crosby
VP Information Systems
UniPro FoodService/Dilgard
P.O. Box 13369
Ft. Wayne, IN 46868-3369
260-422-7531
www.dilgardfoods.com

The opinions expressed are my own and not necessarily the opinion of my
company. Unless I say so.
--
This is the Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries (WDSCI-L) mailing list To post a message
email: WDSCI-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list
options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/wdsci-l.