You need to start at position 8.
From: "RPGLIST" <rpglist@xxxxxxxxxxx>
To: wdsci-l@xxxxxxxxxxxx
Date: 10/17/2014 04:00 PM
Subject: [WDSCI-L] Question on 9.1
Sent by: "WDSCI-L" <wdsci-l-bounces@xxxxxxxxxxxx>
I'm playing around this afternoon with "Totally Free" and I keep getting
errors on the most basic stuff.
Here is an example:
ctl-opt Option(*NoDebugIO:*SrcStmt:*nounref)
p
After I type in the ctl-opt beginning in position 1, it automatically adds
the p spec, so I'm not sure what's driving that.
And then I get an error message:
RNF1501E The Begin/End entry of the Procedure specification is not valid.
RNF0289E Entry contains data that is not valid; only valid data is used.
RNF1508E Unused positions for the Procedure specification are not blank;
default to blanks.
RNF1508E Unused positions for the Procedure specification are not blank;
default to blanks.
RNF0633E An unexpected right parenthesis was encountered; right
parenthesis is ignored.
Is there a config option I need to set to stop this stupid error from
popping up?
I then go back and delete the p and the error message and enter the
following:
dcl-f cllf05;
I get the following error message:
RNF0257E Form-Type entry for main procedure not valid or out of sequence.
I'm hoping this is just a config issue...
Any help would be appreciated.
Dutch
--
This is the Rational Developer for IBM i / Websphere Development Studio
Client for System i & iSeries (WDSCI-L) mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/wdsci-l.
midrange.com
