I thought I remembered something about this on the list a while back, but
I couldn't find anything searching the archives.
I wanted to modify the parameters on a couple of the compile commands we
use. So I went into 'Work with Compile Commands' and made the changes,
clicked Apply then Close. Tested and everything was great. But the next
time I restarted RDi (version 9.1), the changes were gone. I've also
tried to change the order the commands appear in and had similar
result--i.e., the commands change to the order I've set, they stay fine
through a session, but when I restart, everything reverts to where it was
Is there a setting I'm missing or should I open a PMR? Also if anyone's
aware of an open APAR already, can you share the APAR #?
As an Amazon Associate we earn from qualifying purchases.
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.