Re: Problem with Ctrl + Space in RDi 7.5

Jon Paris wrote:

Anyone else having this problem?

If I go to a blank line and start typing a variable name then Ctrl + Space works as expected and gives me the list of variables. Well sort of - see below re qualified names.

I however I type (say) DoU a space and then the first part of the name Ctrl + Space just shows me the DOU op-code - not very helpful.

Nope, it works fine for me. The behavior you're describing is what I see if I haven't actually refreshed the outline. However, once I've created the outline, if I type Dou and Ctrl-space I get a list of the variables in the program (followed by a comprehensive list of special values and the like).

In addition on qualified names while the prompting works for the first part of the name I just get an error beep when trying to use it after the ".".

Again, I get that behavior until I refresh the outline.

The other I've noticed is that any fields that I reference in the source show up in Outline view with the mixed case names I used - I could have sworn that for LikeRec structures etc. it used to only show the upper case version. Not complaining - it actually makes it easy to see which ones I have referenced - just don't recall it in previous versions.

I seem to always remember seeing mixed case; that's certainly what I see now. Maybe upper case for field names from externally described files?

This is a clean install and I have the latest fix pack applied and no other plug-ins have been added (yet!)

I'm going to go check RDPi, but my RDi 7.5 is working fine.

Joe