Re: Prefix commands don't always work

Well, this keeps getting better and better. The prefix commands will
work one minute, and then not the next. Back and forth. Even worse,
when doing a move, it will delete the source line(s), but just insert a
blank line at the target.

As expected, changing to the SEU profile had no impact.

I'm going to go back to WDSC!

Doug


message: 2
date: Fri, 29 Jan 2010 08:57:02 -0600
from: "Edwards, Douglas" <Douglas.Edwards@xxxxxxxx>
subject: [WDSCI-L] Prefix commands don't always work

Hello all,



I just started using RDi (version 7.5), and have pretty much got it
configured so it works like I had WDSC set up. One thing that is really
bugging me is that more often than not, I can't get the prefix commands
to work. I key in the CC and CC commands, and then an A command to copy
the code block, and when I hit the Enter key, all that happens is the
commands disappear and I get a blank line inserted. Then, a little
while later I may try it again, and this time it works. Don't know why
it doesn't always work, and don't know what has happened in between to
suddenly make it work.



Thanks



_____________

The information contained in this message is proprietary and/or confidential. If you are not the intended recipient, please: (i) delete the message and all copies; (ii) do not disclose, distribute or use the message in any manner; and (iii) notify the sender immediately. In addition, please be aware that any message addressed to our domain is subject to archiving and review by persons other than the intended recipient. Thank you.
_____________