×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
Thanks Adam,
The Ctl-F5 is what I was looking for.
I couldn't figure out how to remove the indent markers from the display after the Ctl-S-O.
Jeff Young
Sr. Programmer Analyst
IBM -e(logo) server Certified Systems Exper - iSeries Technical Solutions V5R2
IBM Certified Specialist- e(logo) server i5Series Technical Solutions Designer V5R3
IBM Certified Specialist- e(logo)server i5Series Technical Solutions Implementer V5R3
----- Original Message ----
From: Adam Glauser <adamglauser@xxxxxxxxxxxx>
To: wdsci-l@xxxxxxxxxxxx
Sent: Thursday, January 10, 2008 2:52:11 PM
Subject: Re: [WDSCI-L] Reset Show Block Nesting
Jeff Young wrote:
In the LPEX editor, I can see my indentation for a block group using the Ctl-Shift-O key.
Is there any way to reset the indent lines after I set them?
That depends what you mean by "reset". If you mean that you want added
a block around the existing block, I think you'd need to do Ctrl-Shift-O
again at the higher level of nesting.
If you mean that you want to get rid of the arrows on the left side of
the editor view, then you should use Ctrl+F5 (or Source->Refresh).
midrange.com
