Re: Field values in iSeries debugger

Chandra,

In V6.0, the debugger started to use iSeries Editor as the default editor 
to display the source.  The fly over expression evaluation was available 
in OPM RPG, ILE RPG and ILE COBOL.  Is your OPM program RPG?  If yes, the 
fly over should work.

Could you please switch to use Debugger editor as the editor for debugger, 
and try your scenario again to see if flyover works? 
To do that, go to Window -> Preferences -> Run/Debug -> Compiled Debug, 
and check the "Always use Debugger Editor while debugging" checkbox.


Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx





CRepaka@xxxxxxxxxxxxxxxxxx 
Sent by: wdsci-l-bounces@xxxxxxxxxxxx
12/18/2006 11:53 AM
Please respond to
Websphere Development Studio Client for iSeries <wdsci-l@xxxxxxxxxxxx>


To
wdsci-l@xxxxxxxxxxxx
cc

Subject
[WDSCI-L] Field values in iSeries debugger






I posted this question a while but nobody replied so far. Please share 
your thoughts on this one.

Thanks
Chandra

 
Hi,

I noticed that in iSeries debugger version 6.0.1 we can see the field 
values when we move cursor on to that field for ILE sources only but not 
for the OPM sources. When I was debugging the previous version of RSE I 
could see the values on both OPM and ILE sources but the new version only 
allows us to see values in ILE sources not OPM. Is there any settings we 
need to change or is it a restriction that added in new version?

Thanks
Chandra
X 3314