Re: LPEX CMD "-1" replacement value problem

Hi Craig,

This issue is caused by the same problem as APAR SE26723.
The plan is to fix it in the next release.  If there will be another RSE
service, then the fix may get put in that too.

thanks,

Violaine Batthish
WebSphere Development Studio Client, IBM Toronto Lab


wdsci-l-bounces@xxxxxxxxxxxx wrote on 12/08/2006 07:39:13 AM:

Does IBM know of the problem prompting a parm with a replacement value of
"-1" within a CMD member in the LPEX editor?
For example, F4 on "PARM  KWD(SPLNBR)...SPCVAL((*ONLY 0) (*LAST -1))...".
This gives EVFCL6833E "More than one value, list, or qualified name not
allowed".  Getting rid of the "-1" replacement value makes it prompt

fine.

Same thing for single value replacement values of "-1".  Initially

entering

the "-1" from the good prompt creates the parm lines fine though.
Should I turn this one into IBM?  Thanks!

Craig Strong