Re: WDSCI-L Digest, Vol 4, Issue 578

[Vernon Hamberg <vhamberg@xxxxxxxxxxx>]

Bill - I can't suggest strongly enough that you should call IBM 
support - we just are not the place for extensive support of their 
product - they will be very helpful getting you going and can respond 
exactly to what you are trying to do. We can do a little but just do 
not have the resources to help you enough, I think, get over some of 
these hurdles.

HTH
Vern

At 06:35 AM 11/6/2006, you wrote:



> message: 2
> date: Fri, 3 Nov 2006 14:44:48 -0500
> from: MichaelQuigley@xxxxxxxxxx
> subject: Re: [WDSCI-L] Debugging
>
> The problem should have nothing to do with WDSC.  If you launch debug
> configuration, it just sends the command on to the AS/400 / iSeries /
> System i.  Have you checked to make sure there isn't another copy of the
>
> program in the library list?
>
> I realize that it "shouldn't" have anything to do with WDSc.  I have
> tried everything I can think of to get the correct program to debug
> other than removing the entire WDSc suite and reloading.
>
> I can debug the program using the old standby STRDBG and it works just
> like always.  I am trying to transition to WDSC so I can then train the
> others here on how to use it and avoid the pitfalls and searching that I
> have gone through.
>
> FYI - I tried the link and after 15 minutes of waiting for it to load I
> quit.  I'll try it again later it may be down for maintenance or
> something.
>
> Thanks for the response.
>
> --
> This is the Websphere Development Studio Client for 
> iSeries  (WDSCI-L) mailing list
> To post a message email: WDSCI-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
> or email: WDSCI-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/wdsci-l.