Re: MCH3402 Tried to refer to all or part of an object that no longer exists

Adrie,

Which version of WDSc you are using?

If you are using 6.0 or later, you could right click on a service entry
point in the Service Entry Point view, and select Refresh button after you
re-compile you source.

If you are in 5.1.2, you need to use the "Clear all service entry point for
" drop down (the one in the upper right corner of the Service Entry Point
view) to clear the service entry point.  Then set it again.  By just remove
it and then reset it would not work.

Regards,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx




                                                                           
             Adri.Donkers@achm                                             
             ea.nl                                                         
             Sent by:                                                   To 
             wdsci-l-bounces@m         wdsci-l@xxxxxxxxxxxx                
             idrange.com                                                cc 
                                                                           
                                                                   Subject 
             05/09/2006 10:10          [WDSCI-L] MCH3402 Tried to refer to 
             AM                        all or part of an object that no    
                                       longer exists                       
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           





To all,

When I set an Entry Point on an object, debugging works great. But when I
change the source and recompile, I can't set the Entry Point again on the
object, because I get the above message. When I restart WDSCi it works
well, but that's not a good solution.
Somebody knows a better solution?

Adrie Donker



********************* DISCLAIMER *********************
De informatie in dit e-mail bericht is uitsluitend
bestemd voor de geadresseerde. Verstrekking aan
en gebruik door anderen is niet toegestaan.
Door de electronische verzending van het bericht
kunnen er geen rechten worden ontleend aan de
informatie.
************************************************************

--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.