MCH3402 Tried to refer to all or part of an object

Adrie,
The reason this issue is resolved for you by ending WDSc and restarting
is because your essentially signing off and back on.  Try compiling your
program with the following parameter changes:

DFTACTGRP(*NO)
ACTGRP(*NEW)

While this is not seen by many as an efficient use of ILE I believe it
will solve your immediate problem.  Because I just recently fought with
this exact error message I would guess that you have some combination of
programs running the ILE and some in OPM.  If that is true, then I would
further guess that you have some programs running in the DAG (default
activation group)and some in QILE or some other named activation group.
So, in my opinion, you can either convert all of your programs that will
ever be in that call stream to ILE and get them in the same activation
group or compile your program that will begin the call stream with the
above parameters. 

Tschuess,
Gregory Simmons
Development Programmer, Tech Services
Jack Henry & Associates

------------------------------

message: 6
date: Tue, 9 May 2006 16:10:04 +0200
from: Adri.Donkers@xxxxxxxxx
subject: [WDSCI-L] MCH3402 Tried to refer to all or part of an object
        that no longer exists


To all,

When I set an Entry Point on an object, debugging works great. But when
I
change the source and recompile, I can't set the Entry Point again on
the
object, because I get the above message. When I restart WDSCi it works
well, but that's not a good solution.
Somebody knows a better solution?

Adrie Donker



********************* DISCLAIMER *********************
De informatie in dit e-mail bericht is uitsluitend
bestemd voor de geadresseerde. Verstrekking aan
en gebruik door anderen is niet toegestaan.
Door de electronische verzending van het bericht
kunnen er geen rechten worden ontleend aan de
informatie.
************************************************************