Re: Problem Debugging in Lite

Sorry I forgot to call everyone off I was my own dumb mistake.  Always check
the error listing first before engaging email fingers

Thanks again

Bob Anderson
 

-----Original Message-----
From: wdsci-l-bounces@xxxxxxxxxxxx [mailto:wdsci-l-bounces@xxxxxxxxxxxx] On
Behalf Of Xuan Chen
Sent: Tuesday, February 21, 2006 1:55 PM
To: Websphere Development Studio Client for iSeries
Subject: Re: [WDSCI-L] Problem Debugging in Lite

Hi Bob,

Could you please try to see if you get the same behaviour when using green
screen debugger?  Thanks.

Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx




                                                                           
             "Bob Anderson"                                                
             <banderson@kentwa                                             
             tersports.com>                                             To 
             Sent by:                  "'Websphere Development Studio      
             wdsci-l-bounces@m         Client for iSeries'"                
             idrange.com               <wdsci-l@xxxxxxxxxxxx>              
                                                                        cc 
                                                                           
             02/21/2006 12:44                                      Subject 
             PM                        [WDSCI-L] Problem Debugging in Lite 
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           




Good Afternoon,
             I'm having a problem when debugging a program through Service
Entry Point.

I have compiled a program using the following command:

CRTBNDRPG PGM(NEWPAY/W22004PRT) SRCFILE(NEWPAY/QRPGLESRC) SRCMBR(W22004PRT)
DFTACTGRP(*NO) ACTGRP(NEWPAY) OPTION(*EVENTF *NODEBUGIO) DBGVIEW(*LIST)
OUTPUT(*NONE) REPLACE(*YES)

The compile is clean.  I have set a Service Entry Point and after every
compile I do a refresh on the Service Entry Points. When I run the program
the Service Entry Point kicks in and the debug opens, however the listing
that is shown and that I am stepping through is an old version that doesn't
match my current source.

Anybody have any clue what I am doing wrong

Thanks
Bob Anderson
IT Guy
Kent Sporting Goods
New London OH 44851
banderson@xxxxxxxxxxxxxxxxxxx

--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list To post a message email: WDSCI-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/wdsci-l.


--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list To post a message email: WDSCI-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/wdsci-l.