Re: WDSC 6.0 iseries interactive debugger problem.

Steve,

Could you please try the following scenario:
.  In RSE, right click on the program you want to debug, and choose Debug
(Service Entry) -> Set Service Entry Point.  A specific breakpoint will be
set for your program.
.  Go to your 5250 screen, and run that program.  See if the debug session
could startup.

Thanks,

Xuan Chen,  Problem Determination Tools for iSeries
(905) 413-3769 T/L 969-3769
xuanchen@xxxxxxxxxx




                                                                           
             "Cross, Steve"                                                
             <Steve.Cross@usfc                                             
             .com>                                                      To 
             Sent by:                  <wdsci-l@xxxxxxxxxxxx>              
             wdsci-l-bounces@m                                          cc 
             idrange.com                                                   
                                                                   Subject 
                                       [WDSCI-L] WDSC 6.0 iseries          
             12/21/2005 10:41          interactive debugger problem.       
             AM                                                            
                                                                           
                                                                           
             Please respond to                                             
                 Websphere                                                 
                Development                                                
             Studio Client for                                             
                  iSeries                                                  
                                                                           
                                                                           




Hello,

I'm trying to get the iseries interactive debugger working in WDSC 6.0,
but I get the following job running under the debug window;  State:
<waiting for engine> Connection: local (disconnected).  I would think
this should say my connection is the Iseries and then list the thread
information below it.  How do I get the connection to the Iseries
instead of Local?  Is there another TCP/IP port that has to be opened up
through the firewall?  I had the network team open up 8001 and 4300.

The debug server is started on the Iseries and I'm able to run STRRSESVR
on an interactive job.  What's missing?

Thank you,
Steve Cross
USF IT Technology
(773) 867-3717


-------------------------------------------------------------------------------------

This e-mail is the exclusive, private and confidential property of the
sender. The
information contained in it is intended solely for the use of the sender
and the
intended recipient. If you are not the intended recipient you are hereby
advised that
any unauthorized disclosure, copying, distribution or the taking of any
action in
reliance on the contents of this message is strictly prohibited. If you
have received
this e-mail in error, please notify us immediately by telephone (call the
USF
Corporation Technical Support Center at 1-888-873-8721) and then destroy
this
document and any copies in any form immediately.  Finally, the recipient
should
check this email and any attachments for the presence of viruses. USF
Corporation
accepts no liability for any damage caused by any virus transmitted by this
email.
-------------------------------------------------------------------------------------



--
This is the Websphere Development Studio Client for iSeries  (WDSCI-L)
mailing list
To post a message email: WDSCI-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/wdsci-l
or email: WDSCI-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/wdsci-l.