|
WDSC 6.0.1 Build id: 20050725_1800 I am attempting to debug a process with multiple service programs and underlying procedures. In the previous version of WDSC (5.1...) I could set breakpoints within the lower lever procedures and click the resume button/F8 and the process would stop on the break point in the lower level proc. With WDSC 6.0.1 the break points are ignored, unless I step into the procedure and then click resume/F8. Is there a "run to next breakpoint" or something else that I am missing? It is a real PITA having to step into 4 procedures just to get down to where I need to debug the process. Duane Christen P.S. The step over button/F6 function is also ignoring breakpoints which is less of a problem but is still entirely unexpected. NOTICE: This electronic mail transmission may contain confidential information and is intended only for the person(s) named. Any use, copying or disclosure by any other person is strictly prohibited. If you have received this transmission in error, please notify the sender via e-mail.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
