Debug Service entry point Bugs.

After I set a service entry point I get the following message:
Service entry point is set successfully.

The service entry point can be refreshed through iSeries Service Entry Point(s) 
view if you recompile or update the program or service program later.

There is a check box showing "Dont show this message again." I check it but it 
still comes back every time. 

Then the Refresh that box is telling me about does not even work after a 
recompile. I have to do a clear on the break point and then add it back in. 
Even removing and adding it back in will not work, I must do a clear. 

Is anyone else having these same issues? Have they been reported to IBM?

Chris

-------------------------------------------------

This email transmission and any documents, files or previous

email messages attached to it may contain information that is

confidential or legally privileged. If you are not the intended

recipient, you are hereby notified that any disclosure, copying,

printing, distributing or use of this transmission is strictly

prohibited. If you have received this transmission in error,

please immediately notify the sender by telephone or return

email and delete the original transmission and its attachments

without reading or saving in any manner.



The Evangelical Lutheran Good Samaritan Society.

---------------------------------------------------------